:WGEN<w>:ARBitrary:INTerpolate
Command Syntax
:WGEN<w>:ARBitrary:INTerpolate {{0 | OFF} | {1 | ON}}
<w> ::= 1 or 2 in NR1 format
The :WGEN<w>:ARBitrary:INTerpolate command enables or disables the
Interpolation control.
Interpolation specifies how lines are drawn between arbitrary waveform points:
• When ON, lines are drawn between points in the arbitrary waveform. Voltage
• When OFF, all line segments in the arbitrary waveform are horizontal. The
Query Syntax
:WGEN<w>:ARBitrary:INTerpolate?
The :WGEN<w>:ARBitrary:INTerpolate query returns the current interpolation
setting.
Return Format
{0 | 1}
See Also
•
•
•
•
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
(see
page
1428)
levels change linearly between one point and the next.
voltage level of one point remains until the next point.
":WGEN<w>:ARBitrary:DATA"
":WGEN<w>:ARBitrary:DATA:DAC"
":SAVE:ARBitrary[:STARt]"
":RECall:ARBitrary[:STARt]"
on page 1275
on page 1278
on page 727
on page 715
35
:WGEN<w> Commands
1279
Need help?
Do you have a question about the InfiniiVision MSO-X 4022A and is the answer not in the manual?