Wgen<W>:Output:mode - Keysight Technologies InfiniiVision MSO-X 4022A Programmer's Manual

:WGEN<w>:OUTPut:MODE
Command Syntax
:WGEN<w>:OUTPut:MODE <mode>
<mode> ::= {NORMal | SINGle}
The :WGEN<w>:OUTPut:MODE command specifies whether the defined waveform
is output continuously or as a single cycle (single-shot):
• NORMal — the defined waveform is output continuously.
• SINGle — one cycle of the defined waveform is output when you send the
Query Syntax
:WGEN<w>:OUTPut:MODE?
The :WGEN<w>:OUTPut:MODE? query returns the output mode setting.
Return Format
<mode><NL>
<mode> ::= {NORMal | SINGle}
See Also •
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
(see page 1428)
:WGEN<w>:OUTPut:SINGle command.
Not all waveform types allow single-shot output.
":WGEN<w>:OUTPut:SINGle" on page 1305
35
:WGEN<w> Commands
1303