Connecting The Power Cables And Installing The Shrouds (Option +B051) - ABB ACQ580-34 Hardware Manual

86 Installation example in Rittal VX25 cabinet
• Unfasten the insertion ramp and attach the LCL filter module to bottom plate.
• Attach the drive module pedestal guide plate to the cabinet bottom plate.
• Attach the telescopic insertion ramp to the pedestal guide plate.
• Remove the sheeting from the clear plastic shrouds (option +B051) of the drive module
from both sides.
• Install the top metallic shroud to the drive module.
• Install the back shrouds to the drive module.
• To prevent the drive module from falling, attach its lifting lugs with chains to the cabinet
frame.
• Push the drive module carefully into the cabinet along the telescopic insertion ramp.
Work preferably with help from another person as shown above. Keep a constant
pressure with one foot on the base of the module to prevent the module from falling on
its back.
• Unfasten the insertion ramp and attach the drive module to the bottom plate.
• Attach the LCL filter module and drive module to the punched section.
• Attach LCL filter module to the side of drive module from top and bottom. Reinstall the
cover.
• Connect the LCL filter busbars to the drive module busbars with the connecting busbars.
• Connect the LCL filter fan power supply cable to connector FAN3:LCL.
• Connect the power cables and install the shrouds (option +B051) as described in section
Connecting the power cables and installing the shrouds (option +B051) (page
• Connect the control cables as described in section
internal control unit (page
• Install the air baffles.
Connecting the power cables and installing the shrouds
(option +B051)
Step Tasks (motor cables)
1 Install the grounding terminal to the drive module base.
2 Run the motor cables to the cabinet. Ground the cable shields 360 degrees at the cabinet entry.
68).
Connecting the control cables to the
86).