Eu Declaration Of Conformity (Machinery Directive); Disclaimer; Generic Disclaimer; Cybersecurity Disclaimer - ABB ACQ580-34 Hardware Manual

124 Technical data
• The drive is suitable for use in a circuit capable of delivering not more than 100,000 rms
symmetrical amperes, 600 V maximum when protected by the UL fuses given elsewhere
in this chapter. The ampere rating is based on tests done according to the appropriate
UL standard.
• The cables located within the motor circuit must be rated for at least 75 °C (167 °F) in
UL-compliant installations.
• The input cable must be protected with fuses. The fuses must provide branch circuit
protection in accordance with the national regulations (National Electrical Code (NEC)
or Canadian Electrical Code). Obey also any other applicable local or provincial codes.
Note: Circuit breakers must not be used without fuses in the USA. For suitable circuit
breakers, contact your local ABB representative.
WARNING!
The opening of the branch-circuit protective device may be an indication that
a fault current has been interrupted. To reduce the risk of fire or electric shock,
current-carrying parts and other components of the device should be examined
and replaced if damaged.
• The drive provides motor overload protection. For adjustments, see the firmware manual.
• The drive overvoltage category according to IEC 60664-1 is III.

EU Declaration of Conformity (Machinery Directive)

See The Safe torque off function (page 135)

Disclaimer

￭

Generic disclaimer

The manufacturer shall have no obligation with respect to any product which (i) has been
improperly repaired or altered; (ii) has been subjected to misuse, negligence or accident;
(iii) has been used in a manner contrary to the manufacturer's instructions; or (iv) has failed
as a result of ordinary wear and tear.
￭

Cybersecurity disclaimer

This product is designed to be connected to and to communicate information and data via
a network interface. It is Customer's sole responsibility to provide and continuously ensure
a secure connection between the product and Customer network or any other network (as
the case may be). Customer shall establish and maintain any appropriate measures (such
as but not limited to the installation of firewalls, application of authentication measures,
encryption of data, installation of anti-virus programs, etc) to protect the product, the network,
its system and the interface against any kind of security breaches, unauthorized access,
interference, intrusion, leakage and/or theft of data or information. ABB and its affiliates are
not liable for damages and/or losses related to such security breaches, any unauthorized
access, interference, intrusion, leakage and/or theft of data or information.