Terms And Abbreviations - ABB ACQ580-34 Hardware Manual

Task
Unpack and examine the units.
Make sure that all necessary optional modules and
equipment are present and correct.
Only intact units can be started up.
Examine the installation site. Fasten the base of the
cabinet to the floor.
Route the cables.
Measure the insulation of the supply cable, the motor
and the motor cable and the resistor cable (if present).
Standard drive modules
• Install the additional components into the cabinet: for
example, main disconnector, main contactor, main
AC fuses, etc..
• Install the drive module into the cabinet.
• Connect the motor cables to the drive module termin-
als.
• Connect the brake resistor and DC connection cables
(if any) to the drive module terminals.
• If the main disconnector is installed into the cabinet,
connect it to the drive module terminals and the input
power cabling to the disconnector.
Drive modules with IP20 shrouds (option +B051)
Connect the external control cables to the drive control
unit.
Examine the installation.
Commission the drive.
Operate the drive: start, stop, speed control etc.

Terms and abbreviations

Term
CCU-24
CHDI-01
CMOD-01
CMOD-02
Drive
EMC
EMI
FBIP-21
Description
Type of control unit
115/230 V digital input extension module
Multifunction extension module (external 24 V AC/DC and digital I/O extension)
Multifunction extension module (external 24 V AC/DC and isolated PTC interface)
Frequency converter for controlling AC motors
Electromagnetic compatibility
Electromagnetic interference
BACnet/IP adapter module
Introduction to the manual 23
See chapter/section
Moving and unpacking the unit
Examining the delivery
If the drive module has been non-operational for a year
or more, the converter DC link capacitors need to be
reformed. (Reforming the capacitors)
Examining the installation site
Ambient conditions
Routing the cables
Measuring the insulation of the assembly
Installing the drive module and LCL filter module into
a cabinet
Connecting the power cables and installing the shrouds
(option +B051)
Connecting the control cables and installing option
modules
Manuals for any optional equipment
Step-by-step drawings for an installation example in
Rittal VX25 800 mm wide cabinet
Connecting the control cables
Installation checklist
Start-up
Appropriate firmware manual