72 Electrical installation
Connecting a remote panel, or chaining one panel to several
drives
You can connect a remote ACH-AP-H control panel to the drive, or to chain the control panel
or a PC to several drives on a panel bus with a CDPI-01 communication adapter module.
See CDPI-01 communication adapter module user's manual (3AXD50000009929 [English]).
Connecting a PC
A PC (with eg, the Drive composer PC tool) can be connected as follows:
1. Connect an ACx-AP-x control panel to the unit either
•
by inserting the control panel into the panel holder or platform, or
•
by using an Ethernet (eg, Cat 5e) networking cable.
2. Remove the USB connector cover on the front of the control panel.
3. Connect an USB cable (Type A to Type Mini-B) between the USB connector on the
control panel (3a) and a free USB port on the PC (3b).
4. The panel will display an indication whenever the connection is active.
5. See the documentation of the PC tool for setup instructions.
?
Start
Stop
Loc/Rem
2
2
3b
3a
4
USB connected
?
Stop
Start
Loc/Rem