Connect The Power Cables (And Install The Shrouds For Option +B051) - ABB ACQ580-04 Series Quick Installation Manual

8 Quick installation guide
Connect the power cables (and install the shrouds for option
+B051)
See figure G on page 14.
Step
1
Install the grounding terminal to the drive module base.
Run the motor cables to the cabinet. Ground the cable shields
2
360 degrees at the cabinet lead-through.
Connect the twisted shields of the motor cables to the
3
grounding terminal.
Screw in and tighten the insulators to the drive module by hand.
4
Install the T3/W2 connection terminal to the insulators.
5
Connect the phase conductors to the T3/W2 terminal.
Install the T2/V2 connection terminal to the insulators. See the
6
warning in step 4.
Connect the phase conductors to the T2/V2 connection
7
terminal.
Install the T1/U2 connection terminal to the insulators. See the
8
warning in step 4.
9
Connect the phase conductors to the T1/U2 terminal.
For option +B051 (if there is no bottom plate in the cabinet and
10
degree of protection of IP20 is needed):
• Step drill carefully sufficiently big holes to the inner clear plastic
shrouds for the motor cables to the connected. Smooth the hole
edges. Cut the shroud from the holes to the edge to make it
possible to put the shroud around the cables.
• Remove the plastic sheeting from the shrouds from both sides.
For option +B051: Put the inner clear plastic shrouds of figure O
11
around the motor cables.
For option +B051: Remove the plastic sheeting from the output
12
clear plastic shroud from both sides. Install the shroud to the
drive module.
For option +B051: Install the lower front cover to the drive
13
module.
Step
Ground the input cable shields (if present) 360 degrees at the
1
cabinet lead-through.
Connect the twisted shields of the input cables and separate
2
ground cable (if present) to the cabinet grounding busbar.
Task (motor cables)
WARNING!
Do not use longer screws or
bigger tightening torque than given in the
installation drawing. They can damage the
insulator and cause dangerous voltage to be
present at the module frame.
Task (input cables)
Figure Page
J 14
K 14
L 14
M 14
N 14
- -
- -
- -
- -
O 15
P 15
Q 15
Q 15
Figure Page
- -
- -