Layout Example, Door Closed - ABB ACQ580-34 Hardware Manual

38 Guidelines for planning the mechanical installation

Layout example, door closed

This diagram shows a cabinet layout example with the input power cable entry from top and
the motor cable entry from bottom.
1 Air inlet for the drive module
2 An extra fan is not necessary if an extra air baffle
is used on the cabinet roof (see the following lay-
out examples)
3 Air outlet for the drive module and LCL filter
module and other equipment on the cabinet roof.
An exhaust fan if needed.
4 Drive control panel with DPMP-01 mounting plat-
form (option +J410). The control panel is connec-
ted to the drive module control unit inside the
cabinet.
5 Contactor control switch and emergency stop
switch (connected to the contactor control circuit
inside the cabinet)
Note: The sizes of the air inlet and outlet gratings are critical for proper cooling of the drive module. For losses
and cooling data requirements, see the technical data.
9
7
3
5
6
4
1
2
8
1
6 Operating handle of the disconnector
7 Rubber grommets for degree of protection
8 Roof air flow viewed from top
9
Fan required for IP20, IP42 or IP54 air outlet kit,
has to be ordered separately. See
fans (page 108).
-
Cooling