Start-Up; Contents Of This Chapter; Start-Up Procedure - ABB ACQ580-34 Hardware Manual

Start-up

Contents of this chapter

This chapter describes the start-up procedure of the drive.

Start-up procedure

1. Only qualified electricians are allowed to start-up the drive.
2. Make sure that the installation of the drive module has been checked according to the
checklist in chapter Installation checklist, and that the motor and driven equipment are
ready for start.
3. Perform the start-up tasks instructed by the cabinet-installer of the drive module.
4. Switch the power on, setup the drive control program, and perform the first start of the
drive and motor. See ACQ580 pump control program quick startup guide
(3AXD50000048773 [English]) or ACQ580 pump control program firmware manual
(3AXD50000035867 [English])
5. For drive modules in which the Safe torque off function is in use: Test and validate the
operation of the Safe torque off function. See
11
Acceptance test procedure (page
Start-up 91
12
144).