Connecting A Pc; Connecting A Remote Panel, Or Chaining One Panel To Several Drives; Installing Option Modules - ABB ACH580-04 Hardware Manual

Connecting a PC

WARNING!
Do not connect the PC directly to the control panel connector of the control unit
as this can cause damage.
A PC (with eg, the Drive composer PC tool) can be connected as follows:
1. Connect an ACx-AP-x control panel to the unit either
• by inserting the control panel into the panel holder or platform, or
• by using an Ethernet (eg, Cat 5e) networking cable.
2. Remove the USB connector cover on the front of the control panel.
3. Connect an USB cable (Type A to Type Mini-B) between the USB connector on the
control panel (3a) and a free USB port on the PC (3b).
4. The panel will display an indication whenever the connection is active.
5. See the documentation of the PC tool for setup instructions.
?
Stop Loc/Rem Start
2
Connecting a remote panel, or chaining one panel to several
drives
You can connect a remote ACH-AP-H or ACH-AP-W control panel to the drive, or to chain
the control panel or a PC to several drives on a panel bus with a CDPI-01 communication
adapter module. See CDPI-01 communication adapter module user's manual
(3AXD50000009929 [English]).

Installing option modules

WARNING!
Obey the safety instructions of the drive. If you ignore them, injury or death,
or damage to the equipment can occur.
1. Stop the drive and do the steps in section
you start the work.
2
3b
3a
Electrical safety precautions (page 18)
Electrical installation 97
4
USB connected
?
Stop Start
Loc/Rem
11
before