Configuring The Cameras; Adding The Cameras - Honeywell MAXPRO NVR XE Operator's Manual

C
Cameras are sources for a video input in MAXPRO NVR. The maximum number of cameras
that can configured varies based on the MAXPRO NVR Edition you purchase.
A
To add cameras
1.
2.
3.
4.
MAXPRO NVR Operator's Guide
Note:
To remove a drive, select the check box corresponding to the drive, and then
click Delete.
O NF IG U R IN G T H E C A M E R A S
DDING THE CAMERAS
Click the Configurator tab. The System page displays by default.
Click the Camera tab to open the Camera page.
Under Discover cameras here
• Click to discover the cameras in the network. By default, the check boxes
corresponding to all the discovered cameras are selected.
Note:
The cameras are added based on the Advanced Discovery Settings. See
Configuring the advanced discovery settings
• Click Add to add all the discovered cameras. To add only specific cameras, first
clear the check boxes of the cameras you do not want to add, and then click Add.
The selected cameras appear under the Camera pane.
Note:
The cameras added have the default parameters for all their settings.
Under the Camera pane, select a camera to change the default parameters for the
following settings.
• Enable/Disable - Enables or disables a camera for recording and live video. By
default the check box corresponding to a camera to enable live video preview is
checked. To disable live video preview, clear the check box corresponding to a
camera. The live video appears under Video Preview at the bottom right corner of
the Camera page.
• Number - Displays the camera number. You cannot modify the camera number.
• Camera Name - Displays the camera name. You can type a new camera name
limited to a maximum of 18 alphanumeric characters.
• IP Address - Type the IP address for the camera as applicable.
• Camera Type - Displays the type of camera.
• Fixed/PTZ - Indicates whether the camera is a PTZ or fixed.
C O N F I G U R I N G M A X P R O N V R
on page 42 for more information.
39