Loading Tab Paper In Trays 1 And 2 - Fuji Xerox ApeosPort-VII C7788 Quick Reference

3 Paper and Other Media
4
Load and align the edge of the paper against the left edge of the tray with the side to be
copied or printed on facing down.
Important
Do not load paper above the maximum fill line ("MAX" in the figure). It may cause paper jams or device
malfunction.
Do not place any paper or objects in the empty space on the right side of Trays 1 or 2. It may cause paper
jams or device malfunction.
Note
When using punched paper, load the punched paper as shown in the illustration.
5
Push the tray in gently until it stops.
Important
When inserting the tray, push it gently. Forcibly pushing in the tray may cause device malfunction.
6
Specify the type of the paper loaded when you have changed the paper type.
Reference
For more information on paper type settings, refer to "Changing the Paper Settings" (P.89).

Loading Tab Paper in Trays 1 and 2

The following describes the procedure for loading tab paper in Trays 1 and 2.
Important
Tab paper can be used only for Covers and Separators.
Note
Before loading paper in a tray, fan the paper well. It prevents paper from sticking to each other and reduces
paper jams.
When a paper jam occurs, the device outputs unnecessary paper after you have cleared the paper jam, and
resumes copying or printing. For example, you load 5-tab paper and set [Add Tab Stock] to five. If a paper
jam occurs when copying the fourth page, the device will automatically output the fifth page and the first
page to the third page of the next paper set after you have cleared the paper jam, and then the device
resumes copying.
62