Fuji Xerox ApeosPort-VII C7788 Quick Reference page 55

7 USB memory slot
Insert a USB 2.0 memory device directly here.
Important
A memory card reader or a memory device cannot be connected to the USB memory slot with a USB cable.
Plug in the USB cable to the USB 2.0 interface connector on the rear of the device or the USB Hub (optional).
Note that the device will not recognize the memory on a memory card reader or a memory device when a USB
memory device is already inserted in the USB memory slot.
Note
This feature is not available for some models. An optional component is required. For more information,
contact our Customer Support Center.
8 One-touch buttons (Only available for devices with the Fax service)
Allows you to specify a recipient with the simple press of a button. You can use the buttons
for the Fax, Internet Fax, Scan (E-mail), and Scan to PC jobs.
Turn over the panels to display buttons 1 - 70, M01, and M02.
There are two ways in which address numbers and stored programs are assigned to the
one-touch buttons. Select either of the following:
[Type 1]
The buttons 1 to 70 are used for address numbers and they correspond to the registered
address numbers 0001 to 0070, while the buttons M01 and M02 are used for stored
programs and they correspond to the registered stored programs 1 and 2.
[Type 2]
The buttons 1 to 60 are used for address numbers and they correspond to the registered
address numbers 0001 to 0060, while the buttons 61 to 70, M01, and M02 are used for
stored programs and they correspond to the registered stored programs 1 to 12.
Note
By default, [Type 1] is selected.
This feature is not available for some models. An optional component is required. For more information,
contact our Customer Support Center.
9 One-touch panels (Only available for devices with the Fax service)
Contains the one-touch buttons.
Turn over the panels to display buttons 1 - 70, M01, and M02.
There are two ways in which address numbers and stored programs are assigned to the
one-touch buttons. Select either of the following:
[Type 1]
The buttons 1 to 70 are used for address numbers and they correspond to the registered
address numbers 0001 to 0070, while the buttons M01 and M02 are used for stored
programs and they correspond to the registered stored programs 1 and 2.
[Type 2]
The buttons 1 to 60 are used for address numbers and they correspond to the registered
address numbers 0001 to 0060, while the buttons 61 to 70, M01, and M02 are used for
stored programs and they correspond to the registered stored programs 1 to 12.
Note
By default, [Type 1] is selected.
This feature is not available for some models. An optional component is required. For more information,
contact our Customer Support Center.
10 Paper clip tray
Used for placing paper clips and staples.
Control Panel
55