Animo OptiFresh Touch Service Book page 76

Service menu continued ...
Main item Sub-item
ERROR LOg
2.08
CLEANINg LOg
READ lOG FIlE
RINSE LOg
2.09
Are you sure?
ERASE lOG
MODEL #
2.10
OF1
lOAD DEFAUlTS
# See Section
1.2 Model code
OF4
Item Description
Last 20 error messages including time and date will be saved
Last 31 cleaning actions including time and date will be saved
Last 31 rinsing actions including time and date will be saved
Log will be erased
TYPE CODE The defaults must be loaded when a new circuit board is installed.
When loading the defaults, the OptiFresh Touch model stated on the
type plate must be set. Only after confirming the question 'are you
Stand
sure?' the right model settings will be loaded.
3F1A
Note;
● When you confirm this setting, all factory settings are loaded into
the control and all changed programmed values are lost.
● After loading the defaults, the PIN code is 2-2-2-2-2 again and the
3FAA
language is set to English again. Change if necessary.
76
OptiFresh (Bean) Touch
2017/09 Rev. 0.0