Vmxd Enhanced Dock - Honeywell Thor VM2 User Manual

VMXD Enhanced Dock

Caution: This dock is designed for DC power vehicle-mounted
This dock is designed for use when the Thor VM2 is replacing a Thor VX8 or Thor VX9.
This dock utilizes the existing vehicle wiring from the earlier computer and supports
screen blanking through that wiring.
SKUs
Power
Connection
Serial Ports
USB Ports
Ethernet
CANbus
Audio
Screen
Blanking
Ignition
Control
Note: For the VMX Enhanced Dock: COM1 is used for screen blanking (via the power cable
connector) and is unavailable when the screen blanking box is attached. When a screen
blanking box is attached, any external serial device such as a scanner, must be connected
to the COM2 port on the dock. If a screen blanking box is not connected via the power
cable, the COM1 port on the dock is available for a serial device.
10 Thor VM2 with with Microsoft Windows 7 or Windows Embedded Standard User Guide
applications only.
VMX004VMCRADLE
Designed to connect to existing Thor VX8 or Thor VX9 power cable only, using existing
DC/DC power supply
COM1 and COM2
(see note below)
USB1 port provides host connection via an adapter cable. This port also supports
Honeywell external keyboards.
USB2 port provides two USB host ports via an adapter cable.
Direct USB host connection on top of dock.
RJ-45 Ethernet connection on top of dock.
Note: For Windows 7 and Windows Embedded Standard 7: An upgrade is necessary to
support the Ethernet port on this dock. See
Support.
Note: For Windows Embedded Standard 2009: The Ethernet port is not supported.
CANbus connection via an adapter cable
Headset connection via an adapter cable
Supported via power cable connector. (see note below)
Not supported
Thor VM2 and Enhanced Dock