Place Thor Vm2 In The Dock - Honeywell Thor VM2 Reference Manual

Place Thor VM2 in the Dock

A. Notch on Thor VM2
B. Release lever
1. Locate the notch on the upper rear of the Thor VM2 (item A above).
2. Slide this notch over the top lip (C) of the Dock. Slide the Thor VM2 from side to side on the Dock to make sure it fully
engages on the lip of the Dock. If the Thor VM2 cannot be slid side to side, the lip is engaged.
3. Pull the quick release lever (B) on the Thor VM2 down and push the Thor VM2 against the Dock.
4. Release the quick release lever. The quick release lever catches the lower lip on the Dock and secures the Thor VM2 to
the Dock.
5. If necessary, adjust the viewing angle of the Thor VM2.
When the Thor VM2 is placed in the Dock, the following may happen:
If the Thor VM2 is off and power is connected to the Dock, the Thor VM2 may boot when placed in the Dock. The
l
behavior depends on the Power Configuration Mode selected.
If the Thor VM2 is on and power is connected to the Dock, the Thor VM2 power management timers may change when
l
the Thor VM2 is placed in the Dock.
Please refer to the Thor VM2 Reference Guide for more details.
When the Thor VM2 is removed from the Dock, the following may happen:
If the Thor VM2 is on and power is connected to the Dock, the Thor VM2 power management timers may change when
l
the Thor VM2 is removed from the Dock.
Please refer to the Thor VM2 Reference Guide for more details.
Back of Thor VM2 Front of Quick Mount Smart Dock
C. Upper Lip on Dock
D. Lower Lip on Dock
1-5