Connect CANbus Cable
The CANbus/Audio connector supports a headset adapter cable or a CANbus Y cable.
The Thor VM2 does not support connecting audio and CANbus simultaneously.
See
1. Seat the D15 cable end connector firmly over the CANbus/Audio Connector on the
2. Tighten the thumbscrews in a clockwise direction. Do not over tighten.
3. The CANbus Y cable has a 9 pin F SAE J1939 (Deutsch) and 9 pin M SAE J1939
Install External Antenna
The external antenna cannot be used by devices with an internal antenna.
Caution: If the Thor VM2 has connectors for external antennas, do not
1. Remove the rubber cap, if present, from the antenna connector before connecting
2. Place the antenna over the antenna connector. If only one antenna is used, be sure
3. Push down and twist the antenna base clockwise until secure.
4. Repeat for second antenna, if used.
128
Thor VM2 with with Microsoft Windows 7 or Windows Embedded Standard User Guide
CANbus / Audio Connector
dock.
(Deutsch) connector. Connect the appropriate cable connector as needed.
power up the Thor VM2 without the external antennas
connected. Damage to the WLAN radio may result.
an external antenna.
to connect it to the Wi-Fi Main connector.
for connector pinouts.