Honeywell Thor VM2 User Manual page 102

Vehicle 50-150VDC Power Connection
1. Please review the
2. The Thor VM2 must not be mounted in the dock. The power switch on the dock must
3. Route the cable from the Thor VM2 to the DC/DC power supply. Route the power
4. Cut the cable to length and strip the wire ends.
5. Remove the lid from the DC/DC power supply.
6. Connect the stripped end of the positive wires (red and red/white twisted together or
7. Connect the stripped end of the negative wires (black and black/white twisted
8. Route the wiring from the DC/DC power supply to the vehicle's electrical system. Do
9. Strip the wire ends and connect to the input side of the DC/DC power supply.
10. Use looms and wire ties to secure all wiring as shown.
11. Reattach the cover with the screws.
12. Connect the DC/DC power supply to the vehicle's electrical system as directed
102 Thor VM2 with with Microsoft Windows 7 or Windows Embedded Standard User Guide
Wiring
be turned Off. The power cable must be UNPLUGGED from the dock.
cable the shortest way possible. The cable is rated for a maximum temperature of
105°C (221°F). When routing this cable, it should be protected from physical dam-
age and from surfaces that might exceed this temperature. Do not expose the cable
to chemicals or oil that may cause the wiring insulation to deteriorate. Always route
the cable so that it does not interfere with safe operation and maintenance of the
vehicle.
a single red wire) to the output block. See
together or a single black wire) to the output. See
Note: The input and output blocks each have
two + (plus), two – (minus) and two
(ground) connectors. Either connector
in the block can be used to connect the
matching polarity wire.
not connect to vehicle power at this time.
below:
Caution: For battery powered vehicles:
• + is connected to battery positive.
• - must be connected to battery negative.
• must be connected to the vehicle chassis ground.
Caution: For internal combustion engine powered vehicles:
• + is connected to battery positive.
• - must be connected to battery negative.
• must be connected to the vehicle chassis ground.
Diagram, before beginning power cable install.
Power Cable Identification.
Power Cable Identification.