Honeywell Thor VM2 User Manual page 217

Wireless Zero Config Utility
•
•
To Switch Control to the Wireless Zero Config Utility
1. Select Configuration > Manage Profiles > Globals.
2. Change the value for the Supplicant property value to Third Party.
3. Tap Commit.
4. Restart the Thor VM2.
The Laird Connection Manager passes control to Wireless Zero Config and the WZC
Wireless Information control panel. Using the options in the Wireless Zero Config pan-
els, set up radio and security settings. There may be a slight delay before the Wireless
Zero Config icon indicates the status of the connection.
To Switch Control to LCM
1. To switch back to LCM control, select Configuration > Manage Profiles > Globals.
2. Change the value for the Supplicant property value to Laird.
3. A message appears that a Power Cycle is required to make settings activate properly.
4. Tap Commit.
5. Restart the Thor VM2.
Radio control is passed to the LCM.
Thor VM2 with with Microsoft Windows 7 or Windows Embedded Standard User Guide
The WZC utility has an icon in the toolbar indicating the Wireless Zero Config
application is enabled but the connection is inactive at this time (the device is not
connected to a network). The WZC icon may not be visible until control is passed to
the WZC utility as described below.
You can use either the Wireless Zero Configuration Utility or the Laird
Configuration Manager to connect to your network. The Laird Configuration
Manager is recommended because the Wireless Zero Configuration Utility cannot
control the complete set of security features of the radio.
211