Honeywell Thor VM2 User Manual page 264

Profile Parameters
Parameter
Edit Profile
SSID
Client Name
Power Save
Tx Power
Bit Rate
Auth Type
EAP Type
Encryption
Radio Mode
258 Thor VM2 with with Microsoft Windows 7 or Windows Embedded Standard User Guide
Default Explanation
Default A string of 1 to 32 alphanumeric characters, establishes the name of the
Profile.
Options are Default or ThirdPartyConfig.
Blank A string of up to 32 alphanumeric characters. Establishes the Service Set
Identifier (SSID) of the WLAN to which the client connects.
Blank A string of up to 16 characters. The client name is assigned to the
network card and the device using the network card. The client name may
be passed to networking wireless devices, e.g. Access Points.
CAM Power save mode.
Options are: Constantly Awake Mode (CAM) power save off, Maximum
(power saving mode) and Fast (power saving mode). When using power
management, use FAST for best throughput results.
Maximu Maximum setting regulates Tx power to the Max power setting for the
m current regulatory domain.
Options are: Maximum, 50mW, 30mW, 20mW, 10mW, 5mW, or 1mW.
Auto Setting the rate to Auto will allow the Access Point to automatically
negotiate the bit rate with the client device.
Options are: Auto, 1 Mbit, 2, 5.5, 6, 9, 11, 12, 18, 24, 36, 48 or 54 Mbit.
Open 802.11 authentication type used when associating with the Access Point.
Options are: Open, LEAP, or Shared key.
None Extensible Authentication Protocol (EAP) type used for 802.1x
authentication to the Access Point.
Options are: None, LEAP, EAP-FAST, PEAP-MSCHAP, PEAP-GTC, PEAP-
TLS, EAP-TTLS, or EAP-TLS.
EAP Type chosen determines whether the Credentials button is active
and also determines the available entries in the Credentials pop-up
window.
None Type of encryption to be used to protect transmitted data. Available
options may vary by SCU version.
Options are: None, WEP (or Manual WEP), WEP EAP (or Auto WEP), WPA
PSK, WPA TKIP, WPA CCKM, WPA2 PSK, WPA2 AES, or WPA2 CCKM.
CKIP is not supported in the Thor VM2.
Note: The Encryption type chosen determines if the WEP Keys / PSK
Keys button is active and also determines the available entries in
the WEP or PSK pop-up window.
BGA Specify 802.11a, 802.11b and/or 802.11g rates when communicating
Rates Full with the AP. The options displayed for this parameter depend on the type
of radio installed in the mobile device.
Options:
B rates only (1, 2, 5.5 and 11 Mbps)
BG Rates Full (All B and G rates)
G rates only (6, 9, 12, 18, 24, 36, 48 and 54 Mbps)
BG optimized or BG subset (1, 2, 5.5, 6, 11, 24, 36 and 54 Mbps)
A rates only (6, 9, 12, 18, 24, 36, 48 and 54 Mbps)
ABG Rates Full (All A rates and all B and G rates with A rates preferred)
BGA Rates Full (All B and G rates and all A rates with B and G rates
preferred)
Ad Hoc (when connecting to another client device instead of an AP)
Default:
BGA Rates Full