Power Controls - Honeywell Thor VM2 User Manual

Power Controls

Power Switch
Standard Dock
Power Button
Thor VM2 with with Microsoft Windows 7 or Windows Embedded Standard User Guide
After all cables are connected, the Thor VM2
can be powered on.
There is a power switch located on the back of
the dock. The power switch is a rocker switch.
The power switch has a raised bump to identify
the switch position even when it is hidden from
view. When the side of the switch with the
raised bump is pressed, the power switch is
On. If the dock is connected to external power,
the dock delivers power to the Thor VM2.
Generally, once the dock is powered On, there
Enhanced Dock
is no need to power it off. The dock power can
remain On even when the Thor VM2 is not
attached.
The power button is located at the lower left
of the Thor VM2.
If the Thor VM2 is Off, pressing the power
button starts the power up sequence.
Note: This assumes that the Thor VM2 is
docked in a powered dock or that the
internal UPS battery has a sufficient
charge to power the Thor VM2. If no
external power is available and the UPS
battery does not have a charge,
pressing the power button causes no
action.
If the Thor VM2 is On, pressing the power
button performs the option selected in the
Advanced tab of the Power control panel
(options may vary by OS type):
• Ignore power button press
• Prompt the user to select action
• Shut down (default, an orderly shutdown
is performed)
• Standby/Sleep
• Hibernate
41