Honeywell Thor VM2 User Manual page 103

13. While observing the
14. Use proper electrical and mechanical fastening means for terminating the cable.
15. Provide mechanical support for the cable by securing it to the vehicle structure at
16. Connect the watertight connector end of the power cable to the Thor VM2 dock
17. Secure the power cable to the Thor VM2 using the
18.
19. If using the
20. Press the
21. Press the
Once installation is complete, remember to start the Thor VM2 and select the desired
Power Scheme to enable Auto-On or Manual Control of the Thor VM2 boot up process.
See the Power Schemes tab of the
Note: Ignition control is not available for trucks over 60VDC.
Wiring Diagram
See Caution
statement below
Caution: For battery powered vehicles:
Thor VM2 with with Microsoft Windows 7 or Windows Embedded Standard User Guide
ble to the actual battery terminals of the vehicle. When available, always connect to
unswitched terminals in the vehicle fuse panel, after providing proper fusing.
ATTENTION: For uninterrupted power, electrical supply connections should not be
made at any point after the ignition switch of the vehicle.
Properly sized "crimp" type electrical terminals are an accepted method of termina-
tion. Select electrical connectors sized for use with 18AWG (1mm
approximately one foot intervals, taking care not to over tighten and pinch conduc-
tors or penetrate the outer cable jacket.
power connector by aligning the connector pins to the power connector; push down
on the watertight connector and twist it to fasten securely. Flip the power switch on
the back of the dock to On.
Place Thor VM2 in the
Screen Blanking
Power Switch
Power Button
Existing Circuitry on Vehicle
Forklift Battery
Main Switch
+Vo -Vo
Fuse - See
Warning
statement below
+ -
+
-
DC/DC
Power
Supply
Fuse Requirements, connect the power cable as close as possi-
Dock.
feature, install the screen blanking box or switch.
on the back of the Thor VM2 dock.
on the front of the Thor VM2 to turn on the Thor VM2.
Power Options
User supplied serial
cable for optional
Strain Relief Cable
control panel.
screen blanking
connection,
see below
Red/White (if present)
Red
Black/White (if present)
Black
Green
Blue
(not connected)
2
) conductors.
Clamps.
Quick Mount
Smart Dock
COM1 or COM2
Connector
Power
Connector
103