Honeywell Thor VM2 User Manual page 108

CV61 Adapter Cable
These instructions for use with
Dock
An adapter cable is available to attach the Thor VM2 to a vehicle previously equipped
with a CV61 DC power cable. The adapter cable has a 5-pin connector to match with the
VV61 power supply cable on one end and a 6-pin connector to match to the Thor VM2
on the other end. This section assumes the CV61 power cable is properly connected to
vehicle power. Refer to the CV61 documentation for details.
To Power Connector on Dock
When this adapter cable is used, there is no provision for an ignition switch input.
Therefore the vehicle ignition monitoring function is not available when using this
cable.
Connect to CV61 Power Cable
1. Connect the adapter cable to the CV61 power cable by aligning the connector pins
2. The cable is rated for a maximum temperature of 105°C (221°F). Therefore, routing
3. Provide mechanical support for the cable by securing it to the vehicle structure at
4. Connect the watertight connector end of the power cable to the Thor VM2 dock
5. Secure the power cable to the Thor VM2 using the
6.
7. If using the
8. Press the
9. Press the
108 Thor VM2 with with Microsoft Windows 7 or Windows Embedded Standard User Guide
only.
to the power connector; push down on the watertight connector and twist it to fasten
securely.
this cable it should be protected from physical damage and from surfaces that
might exceed this temperature. Cable should be protected from physical damage
from moving parts. Do not expose the cable to chemicals or oil that may cause the
wiring insulation to deteriorate. Always route the cable so that it does not interfere
with safe operation and maintenance of the vehicle.
approximately one foot intervals, taking care not to over tighten and pinch
conductors or penetrate outer cable jacket.
power connector by aligning the connector pins to the power connector; push down
on the watertight connector and twist it to fasten securely.
Place Thor VM2 in the Dock
Screen Blanking
Power Switch
Power Button
VM1D Standard Dock
To CV41 Power Supply Cable
feature, install the screen blanking box or switch.
on the back of the Thor VM2 dock.
on the front of the Thor VM2 to turn on the Thor VM2.
and VM3D Enhanced
Strain Relief Cable Clamps.