Power Cable Routing
Power cable with right-angle connector
12-48 VDC Vehicles (10-60 VDC Direct Connection)
Caution: For installation by trained service personnel only.
Caution: Use caution when routing the power cable. See
Caution: These instructions for use with
Fuse Requirements
Warning: For proper and safe installation, the input power cable must be
•
•
86
Thor VM2 with with Microsoft Windows 7 or Windows Embedded Standard User Guide
Cautions.
Enhanced Dock
connected to a fused circuit on the vehicle. If the supply
connection is made directly to the battery, the fuse should be
installed in the positive lead within 5 inches of the battery's
positive (+) terminal. Use VM3055FUSE (or equivalent) to
install the fuse as shown below:
For 12VDC input, use the 10A fuse from the kit or a slow blow fuse that has a DC
voltage rating greater than 12VDC.
For 24VDC input, use the 6A fuse from the kit or a slow blow fuse that has a DC
voltage rating greater than 24VDC.
Power cable with straight connector
VM1D Standard Dock
only.
Avoid sharp bends in this
area of the power cable
Power Cable
and
VM3D