Honeywell Thor VM2 User Manual page 160

The mobile Bluetooth scanner / imager requires this information before discovering,
pairing, connecting or disconnecting can occur.
Important: The Thor VM2 Bluetooth address identifier label should remain protected
from damage (rips, tears, spills, soiling, erasure, etc.) at all times. It may be required
when pairing, connecting, and disconnecting new Bluetooth bar code readers.
Thor VM2 with Label
If the Thor VM2 has a Bluetooth address bar code label attached, follow these steps:
1. Scan the Bluetooth address bar code label, attached to the Thor VM2, with the Blue-
2. If this is the first time the Bluetooth scanner has scanned the Thor VM2 Bluetooth
3. Open the EZPair panel (
4. Tap Discover. Locate the Bluetooth scanner in the Discovery panel.
5. Double-tap the stylus on the Bluetooth scanner. The right-mouse-click menu
6. Select Pair as Scanner to pair the Thor VM2 with the Bluetooth mobile scanner.
The devices are paired. The Bluetooth bar code reader responds with a series of beeps
and an LED flashes. Refer to the following section titled
Indications.
Note: After scanning the Thor VM2 Bluetooth label, if there is no beep and no LED flash from the
Bluetooth device, the devices are currently paired.
Thor VM2 without Label
If the Thor VM2 Bluetooth address bar code label does not exist, follow these steps to
create a unique Bluetooth address bar code for the Thor VM2:
Next, create a Bluetooth address bar code label for the Thor VM2.
The format for the bar code label is as follows:
•
160 Thor VM2 with with Microsoft Windows 7 or Windows Embedded Standard User Guide
tooth mobile scanner.
label, the devices are paired. See section titled
If the devices do not pair successfully, go to the next step.
appears.
Bar code type must be Code 128.
Bluetooth Beep and LED
(Start) > Control Panel > Bluetooth).
Indications.
Bluetooth Beep and LED