Honeywell Thor VM2 User Manual page 281

LEAP
To use LEAP (without WPA, also called WEP-LEAP), make sure the following profile
options are used.
1. Enter the SSID of the Access Point assigned to this profile
2. Set EAP Type to LEAP
3. Set Encryption to WEP EAP or Auto WEP (depending on SCU version)
4. Set Auth Type as follows:
See
To use Stored Credentials, click on the Credentials button. No entries are necessary for
Sign-On Credentials as the user will be prompted for the Username and Password when
connecting to the network.
Enter the Domain\Username (if the Domain is required), otherwise enter the Username.
Enter the password. Click OK then click Commit.
Ensure the correct Active Profile is selected on the Main tab and restart. The SCU Main
tab shows the device is associated after the radio connects to the network.
Thor VM2 with with Microsoft Windows 7 or Windows Embedded Standard User Guide
• If the Cisco/CCX certified AP is configured for open authentication, set the Auth
Type radio parameter to Open.
• If the AP is configured to use shared key or passphrase, set the Auth Type radio
parameter to Shared.
• If the AP is configured for network EAP only, set the Auth Type radio parameter to
LEAP.
Sign-On vs. Stored Credentials for information on entering credentials.
275