Honeywell Thor VM2 User Manual page 100

60-144 VDC Vehicles (50-150 VDC Power Supply, Screws on Top of Lid)
These instructions are for use with
Enhanced Dock
This option requires DC/DC power supply Honeywell Part no. VX89303PWRSPLY
shown below.
Shown With Lid Attached
•
If the DC/DC power supply does not have screws in the top of the lid, see
Vehicles (50-150 VDC Power Supply, Screws on Side of
Caution: For installation by trained service personnel only.
Caution: The VX89303PWRSPLY power supply is sealed per IPXX. Usage
Caution: Use caution when routing the power cable. See
100 Thor VM2 with with Microsoft Windows 7 or Windows Embedded Standard User Guide
only.
Lid is secured with screws on the
top of lid.
in areas where moisture can affect the power supply
connections should be avoided. The power supply should be
mounted in a dry location within the vehicle or placed in a
suitable protective enclosure.
Cautions.
VM1D Standard Dock
Shown With Lid Removed
• Input and output connector blocks
under lid.
• Two positive (+), negative (-) and
ground ( ) connections per
terminal block
Lid).
and VM3D
60-144 VDC
Power Cable