Section 4
Basic IED functions
4.8
4.8.1
4.8.2
4.8.3
82
Product information
Introduction
The Product identifiers function identifies the IED. The function has seven pre-set,
settings that are unchangeable but nevertheless very important:
•
IEDProdType
•
ProductDef
•
FirmwareVer
•
SerialNo
•
OrderingNo
•
ProductionDate
The settings are visible on the local HMI , under Main menu/Diagnostics/IED
status/Product identifiers
They are very helpful in case of support process (such as repair or maintenance).
Setting parameters
The function does not have any parameters available in the local HMI or PCM600.
Factory defined settings
The factory defined settings are very useful for identifying a specific version and
very helpful in the case of maintenance, repair, interchanging IEDs between
different Substation Automation Systems and upgrading. The factory made settings
can not be changed by the customer. They can only be viewed. The settings are
found in the local HMI under Main menu/Diagnostics/IED status/Product
identifiers
The following identifiers are available:
•
IEDProdType
•
Describes the type of the IED (like REL, REC or RET). Example: REL670
•
ProductDef
•
Describes the release number, from the production. Example: 1.2.2.0
•
FirmwareVer
•
Describes the firmware version. Example: 1.4.51
•
Firmware versions numbers are "running" independently from the
release production numbers. For every release numbers (like 1.5.0.17)
there can be one or more firmware versions, depending on the small
issues corrected in between releases.
•
IEDMainFunType
1MRK 505 208-UEN B
Technical reference manual