Local Hmi Related Functions; Introduction - ABB Relion 670 Series Technical Reference Manual

Section 3
Local HMI
3.6
3.6.1
42
Alarm indication LEDs and hardware associated LEDs are located on the right
hand side of the front panel. Alarm LEDs are located on the right of the LCD
screen and show steady or flashing light.
• Steady light indicates normal operation.
• Flashing light indicates alarm.
Alarm LEDs can be configured in PCM600 and depend on the binary logic.
Therefore they can not be configured on the local HMI.
Typical examples of alarm LEDs
• Bay controller failure
• CB close blocked
• Interlocking bypassed
• SF6 Gas refill
• Position error
• CB spring charge alarm
• Oil temperature alarm
• Thermal overload trip
The RJ45 port has a yellow LED indicating that communication has been
established between the IED and a computer.
The Local/Remote key on the front panel has two LEDs indicating whether local or
remote control of the IED is active.

Local HMI related functions

Introduction

The local HMI can be adapted to the application configuration and to user preferences.
• Function block LocalHMI
• Function block LEDGEN
• Setting parameters
1MRK 505 208-UEN B
Technical reference manual