Section 4. Programming; Introduction; Product Program Mode - Henny Penny OFG-341 Operator's Manual

4-1. INTRODUCTION

4-2. PRODUCT PROGRAM
MODE
Sept. 2003

SECTION 4. PROGRAMMING

The controls are preset from the factory, but desired Functions
can be programmed in the field. This section includes the Product
Programming Mode, which are the basic settings, and the Level 2
programming, which are the more detailed settings.
This mode allows the operator to change and set various
parameters for each product.
1. Press and hold
shows in the display, followed by "ENTER CODE".
2. Enter code 1, 2, 3. "SELECT PROG PRODUCT' scrolls
across the display.
3. Press and release the desired product button (1 to 12).
To copy product settings from one button to another,
press and hold the product button to be copied until the
display flashes. Then press the product button you are
copying the settings to. The display shows "COPY -X-
TO -Y-?" then, "1=YES 2=NO". Press
the copying.
5. Press and release
in the display. Ex. " NAME"FRIES".
Change Product Names
a. Press and release
digit, starts flashing.
b. Press and release
letter.
c. To continue to the next letter, press
d. Repeat step c until up to 7 letters are entered.
4-1
Model OFE/OFG/OEA/OGA-341, 342 Model OFE/OFG/OEA/OGA-341, 342
for one second until "PROG"
. The name of that product shows
and the first letter, or
to change the flashing
to change this letter.
to complete
. Then press