C1000 Programming Instructions - Henny Penny OFG-341 Operator's Manual

3-4. C1000 OPERATIONS
AND PROCEDURES
(Continued)
3-5. C1000 PROGRAMMNG
INSTRUCTIONS
April 2008
Do not overload, or place product with extreme
moisture content into the basket. 12.5 lbs. (5.7 kg) is
the maximum amount of product per frypot (6.25 lbs.
(2.8 kg) maximum for the split frypot fryers). Failure
to follow these directions can result in shortening
overflowing the frypot. Serious burns or damage to the
unit could result.
9. If the right basket was dropped into the shortening, then
press the right
If the left basket was dropped, then press the left
10. The timer on the appropriate side (right or left) starts
counting down.
The timing operation of the two sides of the control
is entirely independent of each other. One may be set,
started, or stopped without affecting the other.
11. At the end of the Cook Cycle a tone will sound and the
display flashes "DONE". Press
basket from the shortening.
Timer Programming
1. Anytime the cook time is displayed, press
under the appropriate display to change the cook time.
Set-Point Temperature Programming
1. Press once to view the actual shortening
temperature and press
temperature.
2. While the set-point temperature is in the display, press
to change the set-point temperature.
If "LOCK" shows in display when pressing
the controls are locked and must be unlocked before
changing the time or set-point temperature. See C1000
Special Programming Section.
3-8
Model OFE/OFG/OEA/OGA-341, 342 Model OFE/OFG/OEA/OGA-341, 342
.
button and lift the
again to view the set-point
.
,