Henny Penny OFG-341 Operator's Manual page 44

4-3. SPECIAL PROGRAM
MODE (Continued)
Sept. 2003
Audio Effect (SP-6)
This setting lets you add an "audio effect"- i.e. a pulsed or
"warble," sound effect – to the beeps generated in a Cook Cycle.
a. Follow steps 1 and 2 above.
b Press 5 times. "SP-6" and "AUDIO EFFECT"
shows in the display, along with the effect value.
c. Press
The numbers correspond as follows:
0 = normal tone
1 = fast-pulsed tone
2 = slow pulsed tone
3 = warble tone
Type of shortening to be melted - Liquid or Solid (SP-7)
The Melt Cycle can be set to the type of shortening being used.
a. Follow steps 1 and 2 above.
b. Press and release
CYCLE SELECT" flashes on the display, along with
"l=LIQ" or "2=SOLID".
c. Press
The type of shortening being used in the open fryer
determines the amount of heat applied during the Melt
Cycle. If the controls are set to the solid setting, less heat
is applied to the shortening, than if the controls were
set to the liquid option. Too much heat applied to solid
shortening will cause excessive smoking, and could cause
a fire. This setting should match the type of shortening
being used at the time.
When using solid shortening, it is recommended to melt
the shortening on an outside heating source before
placing it in the frypots. The heating elements or burner
tubes must be completely submerged in shortening. Fire
or damage to the frypot could result.
4-7
Model OFE/OFG/OEA/OGA-341, 342 Model OFE/OFG/OEA/OGA-341, 342
to change the sound effect of the tone.
6 times. "SP-7" and "MELT
to toggle from one type to another.