Henny Penny OFG-341 Operator's Manual page 46

4-3. SPECIAL PROGRAM
MODE (Continued)
Sept. 2003
h. To use the right product button 6 as the manual idle
button, press
shows in the display, along with "NO" or "YES".
i. Press
"YES" is displayed, then during a time of low volume,
the operator presses the right product button 6 to
manually enter the Idle Mode.
Filter Tracking Enabled (Sp-9)
The controls can be set to signal the operator when the shortening
needs filtering. The filter tracking must be enabled to program the
number of Cook Cycles between filtering procedures. (See Filter
Cycles paragraph in Product Program Mode Section.)
a. Follow steps 1 and 2 above.
b Press and release
TRACKING ENABLED" flashes on the display, along
with "1,OFF".
c To enable the filter tracking, press
toggle the display from "1,OFF", to "2,MIXED", or,
"3,GLOBAL".
The Mixed setting allows the operator to set different
amounts of Cook Cycles, between filters, for each
product. If the operator wants to have one setting for all
products go to step h.
d. If "2,MIXED" is selected, press
shows in the display followed by "SUGGEST FILTER
AT ..." and a value between 75% and 100%. Press and
release
e. Press and "SP-9B" shows in the display followed
by "LOCKOUT ENABLED?" and "YES" or "NO".
Press and release
4-9
Model OFE/OFG/OEA/OGA-341, 342 Model OFE/OFG/OEA/OGA-341, 342
. "SP-8C" and "USE-6R-FOR IDLE"
to toggle between NO and YES. If
until "SP-9" and "FILTER
and "SP-9A"
to change this value.
to choose yes or no.
to