Henny Penny OFG-341 Operator's Manual page 59

data plate
drain handle
drain interlock switch
drain valve
dumping table
fill lines
filter clips
closed
filter drain pan
filter envelope
filter heater switch
filter pan dolly
filter pump motor
filter screen assembly
filter union
filter valve
flame sensors
(gas fryers only)
fryer brush
frypot
cooking
frypot collar
Sept. 2003
a label or plate located on the right side panel of the fryer that indicates the fryer
type, serial number, warranty date, and other information
the handle used to open and close the drain valve
a microswitch that automatically shuts off the fryer heat in the event the drain
valve is inadvertently opened while the fryer power switch is in the ON position
a valve that allows the shortening to drain from the frypot into the filter drain
pan; the fryer power switch should be in the OFF position before the drain valve
is opened; the drain valve should remain closed at all other times
a table onto which the cooked product is dumped after removal from the frypot
the four lines marked on the interior rear wall of the frypot that show the proper
shortening level (also referred to as level indictor lines)
the clips are the part of the filter screen assembly that holds the filter envelope
a pan that slides under the fryer into which shortening is drained
a fiber envelope into which the filter screen is placed; the end of the envelope is
folded and held closed with filter clips; a part of the filter screen assembly
control panel switch that activates the strip heater (Model OE-100 only)
an optional transport cart for the filter drain pan
the motor that powers the filtering system
an assembly that filters the shortening as it is pumped from the frypot; the
assembly is made up of two filter screens, a filter envelope, two filter clips, and a
crumb catcher (Note: eight head fryers have two filter screens with no crumb
catcher)
the threaded connection between the fryer and the filter system that can be
connected or released without tools
the valve that must be opened to pump shortening back into the frypot during the
filter cycle (Models OE-100, 320, and 340)
the sensors that shut off the gas supply to gas fryers if the pilot lights
go out or do not light
a brush included with the fryer used to scrub the inside of the frypot
the interior portion of the fryer that holds the shortening and the product while
the top flat surface area around the fryer lid
G-2
Model OFE/OFG/OEA/OGA-341, 342 Model OFE/OFG/OEA/OGA-341, 342