Henny Penny OFG-341 Operator's Manual page 40

4-2. PRODUCT PROGRAM
MODE (Continued)
Sept. 2003
10. Press and release
shows in the display along with the load compensation
average temperature. Press and release
change this value to a maximum of 50°F (10ºC) below
setpoint temperature.
11. Press and release
0:00" shows in the display. Press and release
to set an alarm.
Ex: If a Cook Cycle was set at 3 minutes, and an alarm
was to go off after 30 seconds into the Cook Cycle,
"2:30" would be set in the display at this time. When the
timer counts down to 2:30 the alarm sounds.
Up to 4 alarms can be programmed. After the first one is
set, the other alarms can be accessed by pressing
the button again. Additional prompts shows in
the display. These are "NONE", "SHAKE", "STIR",
"ADD", or "PAUSE". Press
select the word to show in the display if an alarm is
programmed. If "PAUSE" is selected on Auto-lift fryers
the basket automatically rises out of the shortening and
timer stops the countdown. Press
the basket and resume the timer.
12. Press and release
in the display along with the preset holding. Press and
release to adjust the holding time, up to 59:59.
To exit the Product Program Mode at any time, press and
hold for 2 seconds.
4-3
Model OFE/OFG/OEA/OGA-341, 342 Model OFE/OFG/OEA/OGA-341, 342
a fifth time and "LCOMP AVG"
a sixth time and "ALARM – 1 AT
buttons to
until "QUALITY TMR" shows
to
to lower