C1000 Special Programming - Henny Penny OFG-341 Operator's Manual

3-6. C1000 SPECIAL
PROGRAMMING
Dec. 2009
Special Programming is used to set the items below:
• Fahrenheit or Celsius
• Initialize System
• Lock or Unlock Controls
• Heat Source – Electric; Gas w/standing pilot;
Gas w/electronic ignition; Gas-Induced Draft
• Vat Type - Split or Full Vat (frypot)
• Oil Type - Solid or Liquid
1. To enter Special Programming, turn off power switch
(either side). Press and hold
switch back on.
2. "SPEC" "PROG" followed by, "DEG" "°F" or "°C". Use
to change to "°F" or "°C".
3. Press and "INIT" shows in the display.
Press and hold the right
"In-2", "In-1" followed by "Init Sys" "DONE DONE".
The controls now are reset to factory parameters, the time
set to 0:00 and temperature 190°F or 88°C.
4. Press and "LOCK" or "UNLOCK" shows in the displays. Use
to change from "LOCK" to "UNLOCK, or vice versa.
5. Press and "FRYR" & "OPEN" show in displays. Use
to change from "PRES" to "OPEN" if needed.
6. Press and "FRYR" shows in the display. Use
change the fryer type: "ELEC" for electric models;
"GAS" for units with standing pilot; SSI for units with
solid state ignition; IDG for units with induced draft gas burners.
7. Press and "VAT" shows in the display. Use
to change the vat (frypot) type from "SPLIT" to "FULL"
or vice versa. Should be set on FULL VAT
8. Press and "MELT" and "Solid" or "LIQD" shows in the
displays. Use
shortening, or "LIQD", if using liquid shortening.
9. Press and hold
time.
3-9
Model OFE/OFG/OEA/OGA-341, 342 Model OFE/OFG/OEA/OGA-341, 342
and turn the power
and display shows "In-3",
to choose "Solid", if using solid
to exit Special Programming at any
to