Fuji Electric ZSS-8 Series Instruction Manual page 71

Output Hold
ＨＣℓ
Output Hold
ＨＣℓ
Setting Range
"Last Meas." : Holds the value for which "Last Meas." is determined by the
"Pre-set" : Holds the %FS value for which range is currently validated.
Example) When range is from 0 to 10ppm, and the set value is 20%FS, the value corre-
O Conversion Hold
2
"Last Meas." : Holds the measurement value for which "Last Meas." is determined by the
the value calculated by O
by the fixed value.
"Pre-set" : Even if O
determined by the
Last Meas. of average value
If you select the "Last Meas" while using the average value output, the analyzer hold the value averaged
before you press the
INZ-TN8ZSS-E
2018-04-01
12:00:00
Pre-set
020
%FS
( )
2018-04-01
Pre-set 020
sponding to 2ppm is output regardless of the measurement value.
value. When the O
2
analog input is entered, it holds the value calculated by O
2
NT key.
NT key.
When "Last Meas." is selected, cursor returns to
the starting position.
When "Pre-set" is selected, numeric value is
highlighted. Change the numeric value by the
key or the
the right by the
After the numeric value is changed, press the
NT key.
NT
12:00:00
%FS
value is fixed, it holds the value calculated
2
- 61 -
key, and move the digit to
key.
NT key.
NT key, and
fixed value which is
2