Fuji Electric ZSS-8 Series Instruction Manual page 108

(11) Materials of
gas-contacting parts
(12) Air purge connection
diameter
(13) Box finish color
(14) Power supply
(15) Power consumption
(16) Calibration interval
(17) Indicator (control unit)
(18) Cable length
(19) Analog output
(20) Analog input
(21) Digital output
(22) Digital input (option)
(23) Alarm output
(screen-displayed)
(24) Display contents
: SUS316, BK7, FKM, PTFE, glass-cloth, silicone
: Rc1/4 (tube  10 × 8)
: Receiver/Transmitter box: gray
Control unit cover: blue
Control unit case: silver
: Rated voltage 100 to 240V AC
Operating voltage 90 to 264 V AC
Rated frequency 50/60 Hz
: Max. rated power: Approximately 80VA or less
: Once every six months (Maintenance cycle may vary depending on
the operating environment.)
: LCD with back light
: Receiver unit to Transmitter unit : Standard 2m (Maximum 25m)
Receiver unit to control unit
: 4 to 20mA DC or 1 to 5V DC × 2 (4) Non-isolated output
Allowable load: 4 to 20mA DC 550Ω or less, 1 to 5V DC 500kΩ or
more (Transmits the measured value and the O2-corrected value,
and/or the transmittance (%T). User can switch between
average values and instantaneous values.)
: 4–20 mA DC, 2 points
Measured gas pressure, measured gas temperature,
measured gas velocity, O2 concentration, water concentration,
or air purge pressure
* Analog inputs are used for the concentration compensation,
the O2 correction, and the alarm output.
: 6 points, SPST-NO (standard) or SPST-NC
Relay contact, contact capacity 24 V DC, 1 A
Low light transmission, device failure, during hold /
during calibration, H/L limit, environmental error, power
interruption
: 3 points
Voltage input, received by photocoupler (operating voltage
12–24 V DC, current 5–20 mA)
Average value reset, switchover between instantaneous
value and moving average value, remote hold
: LD failure, LD temperature error, high gas temperature, air purge
(low pressure), out of range box temperature warning, low light
transmission, PD over range, connection error, AI under, over H-limit
or under L-Limit.
: Component, concentration (instantaneous value, average value O
correction instantaneous value and O
alarm (fault status)
- 98 -
: Standard 5m (Maximum 100m)
correction average value),
2
2
INZ-TN8ZSS-E