Fuji Electric ZSS-8 Series Instruction Manual page 6

AUTION
ANGER
AUTION
INZ-TN8ZSS-E
Wiring
(1) Be sure to connect a ground wire securely to the specified place by per-
forming class D grounding work. Otherwise electric shock or malfunc-
tion may result.
(2) If the power supply voltage exceeds the rating, electric shock or damage
to the instrument may result. Be sure to use the instrument within the
specified rating range.
(3) Be sure to turn off the power before performing wiring work.
(4) Be sure to use a 600V-IV ground wire 1.6 mm or larger in diameter with
sufficient dielectric strength.
(5) Select input/output wires of materials and diameter that satisfy the rating
of each device. If a wire which cannot endure the rating is used, electric
shock or fire may occur.
(6) Fasten the input/output wires to the floor or wall, and use a wire protec-
tion device.
Operation
(1) When handling the standard gas such as calibration gas, read the instruc-
tion manual of the standard gas carefully, and use the gas correctly.
(2) When toxic fumes, corrosive gas or inert gas is used as calibration gas,
be sure that the position of the air ventilation or exhaust port is suitable.
Otherwise you may inhale exhaust gas. Furthermore, suffocation, brain
disorder, circulatory deficit, or contraction of the breathing system may
occur, resulting in death.
(1) Do not touch the switch with a wet hand. Otherwise it may cause electric
shock.
(2) Do not operate the laser gas analyzer for a long time with its door left
open. Otherwise, dust, foreign matter, etc. may stick on internal walls,
thereby causing faults.
(3) Do not touch the unit terminal block during operation. Otherwise, it may
cause electric shock or injury.
(4) Before leaving unused for a long time or restarting after left at such a
status for an extended length of time, follow the directions of each in-
struction manual because they are different from normal starting or
shutdown. Otherwise, adequate performance will not be provided. Fur-
thermore, an accident or fault may be caused.
(5) Do not allow water to go into the gas analyzer. Otherwise, electric shock
or fire in the instrument may be caused.
(6) Do not smoke nor use a flame near the gas analyzer. Otherwise, it may
result in a fire.
- v -