Table of Contents
Advertisement
ANGER
(1) When the analyzer (receiver unit and transmitter unit) is installed on in-
cineration facility, make sure the facility has stopped completely. In-
stalling on the operating facility may cause high temperature gas injec-
tion, resulting in burn.
(2) If the analyzer is installed or removed from the location higher than op-
erator's height, set up a fence to keep someone from approaching under
or near the unit. If the analyzer inadvertently falls off and hits someone,
serious injuries may occur, resulting in death.
AUTION
(1) Be careful not to drop the analyzer on your foot. Otherwise, it may cause
fracture of the bone.
(2) Do not touch the terminal block of each unit of the instrument carelessly
during operation. Otherwise, it may cause electric shock.
(3) Before working, take off a wrist watch, finger ring or the like metallic
accessories. And never touch the instrument with a wet hand to avoid
electric shocks.
(4) If the fuse is blown, eliminate the cause, and then replace it with the one
of the same capacity and type as before. Otherwise, it may cause electric
shock or accident.
(5) Do not wash or splash water on the switch or electrical parts inside the
device. Otherwise it may cause an electric shock, failure, or fire.
(6) Do not use replacement parts other than recommended ones. Otherwise,
adequate performance will not be provided. Furthermore, an accident or
fault may be caused.
(7) Dispose replacement parts such as maintenance parts as incombustibles
in accordance with the local waste disposal requirements.
AUTION
When this product is installed in a flue and as long as no one enters in the
flue, this product can be used as Class 1 laser product. However, be sure to
follow the instructions below for safety because the product emits laser beam
when energized.
-
Do not remove the transmitter unit, the receiver unit, or any part of them from
the flue without our permission. Otherwise, it may cause a loss of eyesight
and/or skin lesion. Consult us if there is a need for removal.
-
O
use the Class 3B laser elements. When anyone enters into the flue, this product is
regarded as a Class 3B product. In this case, safety measures are required; for
example, an entrance detection system, an interlock that stops radiation of laser
beam, etc. Consult us for details.
AUTION
If the cause of any fault cannot be determined despite reference to the in-
struction manual, be sure to contact your dealer or Fuji Electric's technician
in charge of adjustment. If the instrument is disassembled carelessly, you may
get an electric shock or injury.
Maintenance and inspection
Handling of laser equipment
analyzer for high temperature and instrument air purge version O
2
Others
- vi -
analyzer
2
INZ-TN8ZSS-E
Advertisement
Table of Contents
