Step 4A - Ethernet Device Discovery - Datalogic Matrix 120 Product Reference Manual

Rapid Configuration

Step 4A - Ethernet Device Discovery

The following configuration procedure assumes that a laptop computer running
DL.CODE is connected to a factory default reader through the Ethernet port. See
Step 1 - Connect the System.
The User Interface opens and displays a list of all the devices belonging to the
Local Area Network. DL.CODE has a discovery feature to accomplish this task.
The discovery feature will also show devices not belonging to the LAN and
display them in gray (see
1. First the device must be added to the LAN by aligning its IP Address to the
network. The network administrator should provide valid LAN address(es).
2. Find your device in the list by matching its serial number (SN) then click on
the device wrench icon to open the Device Environment Configuration win-
dow.
3. Change the Ethernet Settings (IP Address, Subnet Mask, Gateway Address
etc.) according to the network requirements.
10
Figure 10 - Device Discovery
Figure 10 -).
Matrix 120