Serial Connections - Datalogic Matrix 120 Product Reference Manual

Serial Connections

To connect the system in a Serial point-to-point configuration, you need the
hardware indicated in
Host from the Matrix 120 main serial interface.
Matrix 120 power and I/O device connections take place through the CBX
connection box using the CAB-1011 accessory cable.
When One Shot or Phase Mode Operating mode is used, the reader is activated by
an External Trigger (photoelectric sensor) when the object enters its reading
zone.
10-30 Vdc
External Power for Matrix 120
and I/O Accessories
Matrix 120
For device configuration through DL.CODE, it is recommended to use either the Ether-
net or USB interface (depending on your model). See USB Connection.
It is not recommended to use the Main Serial interface for configuration unless the
NOTE other interfaces are not available.
Product Reference Guide
Figure 3 -. In this layout the data is transmitted to the
CAB-1011


Figure 3 - Serial Point-to-Point Layout
Step 1 - Connect the System

CBX
Main Serial Interface (RS232 or RS422 Full-Duplex

Optional Outputs


External Trigger (for One Shot or Phase Mode)
Host
3