Upload Configuration - Optical Systems Design OSD2512 User Manual

UPLOAD CONFIGURATION


Maintenance Configuration
It is possible to upload a file from the web browser to all the files on the switch,
except default-config which is read-only.
Select the file to upload, select the destination file on the target, then click
.
If the destination is running-config, the file will be applied to the switch
configuration. This can be done in two ways:

Replace mode: The current configuration is fully replaced with the
configuration in the uploaded file.

Merge mode: The uploaded file is merged into running-config.
If the flash file system is full (i.e. contains default-config and 32 other files, usually
including startup-config), it is not possible to create new files. Instead an existing file
must be overwritten or another file must be deleted.
PAGE 395
OPTICAL SYSTEMS DESIGN

Upload
OSD2512 OPERATOR MANUAL
DOC ID: 10118101