Optical Systems Design OSD2512 User Manual page 15

1. Connect the Console Port on UUT to PC with USB cable (Type A to Type B).
2. Using HyperTerminal, SecureCRT, etc to set up the following parameters.

Baud Rate: 115200

Data Bits: 8

Parity: None

Stop Bits: 1

Flow Control: None
3. Check the link by pressing <ENTER>. The line should jump to the next line.
4. Using the Username and password to login the switch
5. If there is no user input for a period of time, the user will be locked out and will require to re-
enter by pressing ENTER.
6. The admin username is operating at the highest priveldge level (level 15) and has full control
over the OSD2512 and its configuration. On this level, the admin can reset the OSD2512
configuration to factory default.
PAGE 15
OPTICAL SYSTEMS DESIGN
OSD2512 OPERATOR MANUAL
DOC ID: 10118101