Optical Systems Design OSD2512 User Manual page 224

QOS INGRESS PORT POLICERS

Configuration QoS
This page allows you to configure the Policer settings for all switch ports.
The displayed settings are:
Port
The port number for which the configuration below applies.
Enable
Enable or disable the port policer for this switch port.
Rate
Controls the rate for the port policer. This value is restricted to 100-3276700 when "Unit" is
kbps or fps, and 1-3276 when "Unit" is Mbps or kfps. The rate is internally rounded up to the
nearest value supported by the port policer.
Unit
Controls the unit of measure for the port policer rate as kbps, Mbps, fps or kfps.
Flow Control
If flow control is enabled and the port is in flow control mode, then pause frames are sent
instead of discarding frames.
PAGE 224
OPTICAL SYSTEMS DESIGN

Port Policing
OSD2512 OPERATOR MANUAL
DOC ID: 10118101