Optical Systems Design OSD2512 User Manual page 244

Note1: On mirror mode, the device only supports one destination port.
Note2: The destination port needs to disable MAC Table learning.
CONFIGURATION GUIDELINE FOR ALL FEATURES
When the switch is running on Remote Mirroring mode, the administrator also needs
to check whether or not other features are enabled or disabled.
For example, the administrator is not disabled the MSTP on reflector port. All monitor
traffic will be blocked on reflector port.
All recommended settings are described as follows.
Impact
arp_inspection High
acl Critical
dhcp_relay High
dhcp_snooping High
ip_source_guard Critical
ipmc/igmpsnp Critical
ipmc/mldsnp Critical
lacp Low
lldp Low
mac learning Critical
mstp Critical
mvr Critical
nas Critical
psec Critical
qos Critical
upnp Low
mac-based vlan Critical
protocol-based vlan Critical
vlan_translation Critical
voice_vlan Critical
mrp Low
mvrp Low
Note:
* -- must
o -- optional
Impact:
Critical/High/Low
Critical 5 packets -> 0 packet
PAGE 244
OPTICAL SYSTEMS DESIGN
Source
Reflector Port Intermediate Port
Port
* disabled
* disabled
* disabled
* disabled
* disabled
* disabled
* disabled
* authorized
* disabled
* unlimited
* disabled
* disabled
* disabled
* disabled
OSD2512 OPERATOR MANUAL
Destination
Port
* disabled
* disabled * disabled
* disabled
* disabled
* disabled * disabled
o disabled
o disabled
* disabled * disabled
o disabled
* authorized * authorized
* disabled * disabled
* unlimited * unlimited
o disabled
* disabled
* disabled
* disabled * disabled
* disabled
o disabled
o disabled
DOC ID: 10118101
Remote Mirroring
VLAN
un-conflict
un-conflict
un-conflict