Qos Control List Configuration - Optical Systems Design OSD2512 User Manual

QOS CONTROL LIST CONFIGURATION


Configuration QoS
This page shows the QoS Control List (QCL), which is made up of the QCEs. Each
row describes a QCE that is defined. The maximum number of QCEs is 256 on each
switch.
Click on the lowest plus sign to add a new QCE to the list.
QCE
Indicates the QCE id.
Port
Indicates the list of ports configured with the QCE or 'Any'.
DMAC
Indicates the destination MAC address. Possible values are:
Any: Match any DMAC.
Unicast: Match unicast DMAC.
Multicast: Match multicast DMAC.
Broadcast: Match broadcast DMAC.
The default value is 'Any'.
SMAC
Match specific source MAC address or 'Any'.
If a port is configured to match on destination addresses, this field indicates the DMAC.
Tag Type
Indicates tag type. Possible values are:
Any: Match tagged and untagged frames.
Untagged: Match untagged frames.
Tagged: Match tagged frames.
The default value is 'Any'.
VID
Indicates (VLAN ID), either a specific VID or range of VIDs. VID can be in the range 1-4095
or 'Any'
PCP
Priority Code Point: Valid values of PCP are specific (0, 1, 2, 3, 4, 5, 6, 7) or range (0-1, 2-3,
4-5, 6-7, 0-3, 4-7) or 'Any'.
PAGE 238
OPTICAL SYSTEMS DESIGN

QoS Control List
OSD2512 OPERATOR MANUAL
DOC ID: 10118101