System Log Configuration - Optical Systems Design OSD2512 User Manual

SYSTEM LOG CONFIGURATION


Configuration System
Configure System Log on this page.
Server Mode
Indicates the server mode operation. When the mode operation is enabled, the syslog message
will send out to syslog server. The syslog protocol is based on UDP communication and
received on UDP port 514 and the syslog server will not send acknowledgments back sender
since UDP is a connectionless protocol and it does not provide acknowledgments. The syslog
packet will always send out even if the syslog server does not exist. Possible modes are:
Enabled: Enable server mode operation.
Disabled: Disable server mode operation.
Server Address
Indicates the IPv4 host address of syslog server. If the switch provide DNS feature, it also can
be a domain name
Syslog Level
Indicates what kind of message will send to syslog server. Possible modes are:
Error: Send the specific messages which severity code is less or equal than Error (3).
Warning: Send the specific messages which severity code is less or equal than Warning (4).
Notice: Send the specific messages which severity code is less or equal than Notice (5).
Informational: Send the specific messages which severity code is less or equal than
Informational (6).
Buttons
: Click to save changes.
: Click to undo any changes made locally and revert to previously saved
values.
PAGE 42
OPTICAL SYSTEMS DESIGN

Log
.
OSD2512 OPERATOR MANUAL
DOC ID: 10118101