Password - Siemens SINUMERIK 840Di Function Manual

Detailed Description
2.2 Functions
Protection Type
level
5 Keyswitch position 2
6 Keyswitch position 1
7 Keyswitch position 0
Access features
• Protection level 0 provides the greatest number of access rights, protection level 7 the
• If certain access rights are granted to a protection level, these protection rights
• Conversely, protection rights for a certain protection level can only be altered from a
• Access rights for protection levels 0 to 3 are permanently assigned by Siemens and
• Access rights can be set by querying the current keyswitch positions and comparing the
• Options can be protected on each protection level. However, option data can only be
• Access rights for protection levels 4 to 7 are only suggestions and can be altered by the
2.2.5.2

Password

Set password
The password for a protection level (0 – 3) is entered via the HMI user interface.
Example: HMI Advanced
DIAGNOSTICS operation area, softkey: SET PASSWORD
References:
/BAD/ Operator's Guide HMI Advanced
2-32
Users
End user: Skilled operator
without programming
knowledge
End user: Trained operator
without programming
knowledge
End user: Semi-skilled
operator
least.
automatically apply to any higher protection levels.
higher protection level.
cannot be altered (default).
passwords entered. When a password is entered it overwrites the access rights of the
keyswitch position.
entered in protection levels 0 and 1.
machine tool manufacturer or end user.
Access to (examples)
Lower than protection level
0 to 3; defined by end user
Example:
Program selection only, tool-wear entries, and work-
offset entries
Example:
No entries and program selection possible,
only the machine control panel can be operated
Various NC/PLC Interface Signals and Functions (A2)
Function Manual, 08/2005 Edition, 6FC5397-0BP10-0BA0