Siemens SINUMERIK 840Di Function Manual page 4

Preface
Hotline
If you have any questions, please contact the following hotline:
A&D Technical Support
Phone: +49 (0) 180 / 5050 - 222
Fax: +49 (0) 180 / 5050 - 223
E-mail:
Internet:
If you have any comments, suggestions, or corrections regarding this documentation, please
fax or e-mail them to:
Fax: +49 (0) 9131 / 98 - 63315
E-mail:
Fax form: See the reply form at the end of the document.
Website address
http://www.siemens.com/motioncontrol
Objective
The Descriptions of Functions provide the information required for configuration and
installation.
Target groups
The Descriptions of Functions are designed for:
• Design engineers
• PLC user-program programmers
• Startup engineers once the system has been configured and set up
• Maintenance personnel responsible for inspecting and interpreting status signals and
Structure of the Function Manual
Structure of this Function Manual:
• Inside title page (page 3) with the title of this function manual, the SINUMERIK controls
• The description of each function is a separate book.
• Appendix with list of abbreviations and terms.
An overview of the functions described in this function manual is found on page three. The
functions are listed in alphanumeric order of their abbreviations (e.g. A2, A3, etc.). This
sequence also includes the Description of Functions books in the Function Manual.
iv
mailto:adsupport@siemens.com
http://www.siemens.com/automation/support-request
mailto:motioncontrol.docu@siemens.com
alarms
and the software and version for which this edition of the function manual applies, as well
as the overview of the descriptions of functions.
Function Manual, 08/2005 Edition, 6FC5397-0BP10-0BA0
Basic Machine